Por favor, use este identificador para citar o enlazar este ítem: http://dspace.espoch.edu.ec/handle/123456789/14896
Título : Diseño de un biorreactor para la obtención de compost a partir de hojas de mora y estiércol de cuy para el grupo de investigación ENAMPROD de la Facultad de Mecánica
Autor : Coyachamín Chiliquinga, Jefferson Augusto
Director(es): Zambrano Vinueza, Mayra Paola
Tribunal (Tesis): Vargas Guambo, Blanca Irene
Palabras claves : TECNOLOGÍA Y CIENCIAS DE LA INGENIERÍA;INGENIERÍA QUÍMICA;BIORREACTOR;TEMPERATURA;COMPOST;MICROORGANISMO DE MONTAÑA;RELACIÓN CARBONO/NITRÓGENO
Fecha de publicación : 29-ene-2021
Editorial : Escuela Superior Politécnica de Chimborazo
Citación : Coyachamín Chiliquinga, Jefferson Augusto. (2021). Diseño de un biorreactor para la obtención de compost a partir de hojas de mora y estiércol de cuy para el grupo de investigación ENAMPROD de la Facultad de Mecánica. Escuela Superior Politécnica de Chimborazo. Riobamba.
Identificador : UDCTFC;96T00612
Abstract : The objective of this research work is to design a bioreactor for obtaining organic compost using solid waste from guinea pig manure and blackberry leaves. As a first step, samples of guinea pig manure were obtained in the city of Riobamba, a physical-chemical analysis was carried out on the samples to determine the best composition in terms of the C / N ratio, for the blackberry leaves C / N = 11, 64; guinea pig manure C / N = 11.61; mountain microorganism C / N = 11.69, the latter as an additional contribution in the investigation to verify the effectiveness in the mineral enrichment of organic compost. three defined compositions were made: A, B, C; that helped to monitor and control variables such as temperature, pH, humidity, and aeration throughout the composting process for three months. Based on the variables obtained, the equipment was sizing with the following specifications: cylinder with a capacity of 578.5 L of stainless steel with dimensions: length = 244 cm, width = 122 cm and thickness = 2 mm; with 20 16mm perforations for the air passage, this will be located on a container of dimensions: length = 120 cm, width = 50 cm and a height of 20 cm with 4 wheels that will allow the uniform turning off a load of organic material, It will rotate with the help of a one HP motor with an I = 60-30 rpm with a pulley and single-channel type B belt, for homogeneous aeration and humidification. Finally, the results of the physical-chemical analysis of the product obtained for the C / N ratio in A: C / N = 11.64; B: C / N = 11.66; C: C / N = 11.57; According to the Chilean standard NCh2880 class A compost was obtained. In conclusion, the compost can be used for the enrichment of native crops of smaller size.
Resumen : El presente trabajo de investigación tiene como principal objetivo diseñar un biorreactor para la obtención de compost orgánico mediante el aprovechamiento de residuos sólidos de estiércol de cuy y hojas de mora. Como primer paso se procedió a la obtención de muestras de la materia orgánica antes mencionada provenientes de la ciudad de Riobamba, se realizó un análisis físico- químico a las muestras para determinar la mejor composición en cuanto a la relación C/N, para las hojas de mora C/N=11,64; estiércol de cuy C/N=11,61; microorganismo de montaña C/N=11,69 este último como un aporte adicional en la investigación para comprobar la eficacia en el enriquecimiento mineral del compost orgánico. Se realizaron 3 composiciones definidas: A, B, C; que ayudaron al monitoreo y control de variables como temperatura, pH, humedad y aireación durante todo el proceso de compostaje por 3 meses. En base a las variables obtenidas se realizó el dimensionamiento del equipo con las siguientes especificaciones: cilindro con capacidad de 578.5 L de acero inoxidable de dimensiones: longitud=244 cm, ancho=122 cm y espesor= 2 mm; con 20 perforaciones de 16mm para el paso de aire, este se ubicará sobre una cuna de soporte de dimensiones: longitud= 120 cm, ancho=50 cm y una altura de 20 cm con 4 ruedas que permitirán el volteo uniforme de la carga del material orgánico, que girará con ayuda de un motor de un HP con un I = 60-30 rpm con polea y banda tipo B de un solo canal, para una aireación y humectación homogénea. Finalmente, los resultados del análisis fisicoquímico del producto obtenido para relación C/N en A: C/N =11,64; B: C/N=11,66; C: C/N=11,57; de acuerdo a la norma chilena NCh2880 se obtuvo compost de clase A. En conclusión, el compost puede ser utilizado para el enriquecimiento de cultivos nativos de menor tamaño.
URI : http://dspace.espoch.edu.ec/handle/123456789/14896
Aparece en las colecciones: Ingeniero/a Químico/a

Ficheros en este ítem:
Fichero Descripción Tamaño Formato  
96T00612.pdf1,63 MBAdobe PDFVista previa
Visualizar/Abrir


Este ítem está sujeto a una licencia Creative Commons Licencia Creative Commons Creative Commons