Por favor, use este identificador para citar o enlazar este ítem: http://dspace.espoch.edu.ec/handle/123456789/20267
Título : “Síntesis y caracterización de un bioplástico elaborado a partir de cáscara de papaya (Carica papaya maradol roja) y maíz (Zea mays)”
Autor : Dominguez Manzano, Hamilton Isrrael
Director(es): Flores Fiallos, Linda Mariuxi
Tribunal (Tesis): Villegas Freire, Cristina Nataly
Palabras claves : PAPAYA (Carica papaya maradol roja);MAÍZ (Zea mays);ALMIDÓN;RENDIMIENTO;BIOPLÁSTICO;BIOPELÍCULA
Fecha de publicación : 14-dic-2022
Editorial : Escuela Superior Politécnica de Chimborazo
Citación : Dominguez Manzano, Hamilton Isrrael. (2022). “Síntesis y caracterización de un bioplástico elaborado a partir de cáscara de papaya (Carica papaya maradol roja) y maíz (Zea mays)”. Escuela Superior Politécnica de Chimborazo. Riobamba
Identificador : UDCTFC;96T00875
Abstract : The objective of this study was to increase a biodegradable film of papaya (Carica papaya red maradol red) and corn (Zea mays) peel for food wrapping based on the physical, chemical and microbial domain, chemical and microbial domain of the raw materials and then proceed to the extraction of starches according to the instructions of the Food and Agriculture Organization of the United Nations (FAO) using a 2k experimental design (with speed and time as variables, 4 treatments were acquired and each treatment was replicated 4 times), 375 mL of water was applied per sample to determine the optimum yield and then for this according to the INEN 1456 standard. The standards were carefully analyzed and then four treatments were used to obtain bioplastics, processing treatments, each treatment to acquire different concentrations of starch for papaya (3.5 % to 4 %) and plasticizers (2 % to 3 %), for corn (3 % to 3.5 %) and plasticizers (2 % to 3 %), at constant concentration, temperature and time of vinegar and water, followed by sensory tests for the formation of biofilms in all treatments performed, determined some observations of the most notorious TP2 and TM2, biodegradable plastic sheets by contact sticking, TP3 tends to bend after finishing drying, in addition to tests such as humidity, depending on the conditions TP2, TM2, TP4, TM4 (25.18%; 21.93%; 26.23%; 28.50%), while the solubility of TP3 is 59.304 and TM2 39.92%. Two samples were mechanically tested and the benefit was TP1 2.06. E+01 MPa, modulus of elasticity and TM2 1.83. E+01 MPa. Using aerobic media, the biofilms decompose in approximately 42 days.
Resumen : El objetivo de este estudio fue incrementar una película biodegradable de cáscara papaya (Carica papaya red maradol roja) y de maíz (Zea mays) para envoltura de alimentos en base al dominio físico, químico y microbiano de las materias primas y luego proceder a la extracción de los almidones de acuerdo a las instrucciones de la Organización de las Naciones Unidas para la Agricultura y la Alimentación (FAO) empleando un diseño experimental 2k (con la velocidad y el tiempo como variables, se adquirieron 4 tratamientos y cada tratamiento se replicó 4 veces), se aplicó 375 mL de agua por muestra para determinar el rendimiento óptimo y luego para esto de acuerdo a la norma INEN 1456. Los estándares fueron analizados cuidadosamente y luego se utilizaron cuatro tratamientos para obtener bioplásticos, tratamientos de procesamiento, cada tratamiento para adquirir diferentes concentraciones de almidón para papaya (3,5 % a 4 %) y plastificantes (2 % a 3 %), para maíz (3 % a 3,5 %) y plastificantes (2 % a 3 %), a concentración, temperatura y tiempo constantes de vinagre y agua, seguido de pruebas sensoriales para la formación de biopelículas en todos los tratamientos realizados, determinaron algunos observaciones de los TP2 y TM2 más notorios, las láminas de plástico biodegradable mediante el contacto se pegan, TP3 tiende a doblarse después de terminar el secado, además de pruebas como humedad, dependiendo de las condiciones TP2, TM2, TP4, TM4 (25,18%; 21,93%; 26,23%; 28,50%), mientras que la solubilidad del TP3 es del 59,304 y TM2 39,92%. Se probaron mecánicamente dos muestras y el beneficio fue TP1 2,06. E+01 MPa, módulo de elasticidad y TM2 1,83. E+01 MPa. Usando medios aeróbicos, las biopelículas se descomponen en aproximadamente 42 días.
URI : http://dspace.espoch.edu.ec/handle/123456789/20267
Aparece en las colecciones: Ingeniero/a Químico/a

Ficheros en este ítem:
Fichero Descripción Tamaño Formato  
96T00875.pdf4,4 MBAdobe PDFVista previa
Visualizar/Abrir


Este ítem está sujeto a una licencia Creative Commons Licencia Creative Commons Creative Commons